1 / 4
Car cup holder with TPU/FLEX adapter that fits in multiple size holders — zdjęcie 1
1 / 4

Car cup holder with TPU/FLEX adapter that fits in multiple size holders

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

2 part car cup holder with compressible base (TPU or FLEX) to allow larger diameter cups to be held in car cup holders.

Ocena
0 / 5
Polubienia
1
Pobrania
18
Wydruki
0
Wyświetlenia
188
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial

My wife asked me for an adapter for our sodastream bottles for the car. Although easy enough to design and make, each of our cars has different diameter cup holders. I could not just download any model since they would not necessarily fit.  Thus, I would need to design and print a different model for each. Even then, there would be a bit of a wiggle unless the tolerances were perfect (as well as the measurements). Thus, the idea for this model was born. 

The unique part of this model is the base. It is designed to be printed in a flexible filament (in my case I printed it in TPU).

CUP HOLDER SETTINGS:

Structural or strength setting if available on your printer

The top (the cup holder itself) can be printed with various filaments. However, since the inside of a car can get quite hot in the summer heat, I would avoid standard PLA. Depending on how heavy the cup/mug, you may want to print the top with extra walls (I used the standard structural setting on my Prusa Core One and the strength setting on my Centauri carbon which all worked well). 

ADAPTER SETTINGS: I recommend the following settings with a flexible filament:

Perimeters/wall loops/wall line count: 1

Top layers: 1 or 2 (the more layers the stiffer it will become) 

Infill 10%

Infill pattern: gyroid

If you want the adapter base a little stiffer for a tighter fit, you can use an extrusion width/line width of 0.6mm (yes, a 0.4mm nozzle can do this or you can just switch out to a 0.6mm nozzle)

The TPU base has a larger diameter for the cup holder on the top compared to the bottom. This is so that the two will fit together without glue or an adhesive. The small slits are present so that you can peel the inner ring back so that you can wrap it around the cup holder base. I used my finger, but you can also use a butter knife or similar long object to peel the inner ring around.

Tagi