ODROID N2/N2+ Wall Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Easily mount an ODROID N2/N2+ to a vertical surface or wall.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 195
- Wydruki
- 2
- Wyświetlenia
- 1367
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
This bracket for the ODROID N2/N2+ makes it super easy to mount on a wall. This version improves on the original design by introducing a sacrificial layer for the mounting holes which eliminates the need for supports when printing.
This version also increases the distance between the N2/N2+ and the wall which allows for better airflow across the heatsink. If one wishes to mount the N2/N2+ closer to the wall, simply split the model at the desired height in your favorite slicer prior to printing.
Secure the left and right brackets to the N2/N2+ heatsink with four M3 x 30mm screws.
If you are looking for a printable case for the N2/N2+ check out my case here.
The OROID N2/N2+ is a fantastic single board computer with roughly 2x the power of a Raspberry Pi 4. The N2+ powers the Home Assistant Blue device and I highly recommend it.
Printing
- Print in PLA, PETG, or PC. If the N2/N2+ will be in warm conditions or overclocked consider using a heat-tolerant filament like PETG or PC instead of PLA.
- Print using a .2 or .3 layer height.
- Use 4-6 perimeters/shells.
- STLs are pre-positioned in the correct print orientation.
- Supports not required.
Happy Printing!