Mintion Nozzle Camera (Heat Resistant) - Prusa i3 MK3S+

I used the design by @KimFU_330752 to mount my mintion nozzle cam, but there were some issues:

1) The mount arm softened and drooped due to the heat buildup from the camera and the heated bed.
2) The camera angle wasn't ideal to point at the nozzle.
3) It was difficult to print.
4) The ribbon cable clips were too flimsy.

Quick Request  - This took a lot of time to design and test. If you purchase anything for this build, please use at least one of the links below. Anything you purchase during a shopping session where you clicked an affiliate link earns me a commission. It's only like $0.25 but every little bit helps :-) Thank you!

My remix adds:
1) Space to attach a ~10mm heatsink to the camera board with thermal glue.
2) A hollow channel to insert a 2mm brass rod which acts as a skeleton, minimizing droop.
3) Changes to minimize support requirements and improve printability.
4) A .3mf file with support settings and paint-on supports for reference.
5) Three variants with differnt camera pointing angles.

Notes:
• Choose the highest temperature filament you're able to print.
• Overture ASA is the only ASA I've found that doesn't need a heated chamber.
• To mount the ribbon cable, start in the middle and use a back-and-forth bending motion.
• I've attached screenshots with some tips on slicing.
• Snug support enabled @ 45° overhang threshold w/ blockers

Affiliate Links:
Heatsinks: https://amzn.to/4shQSI9
Thermal Glue: https://amzn.to/476RHeg
2mm Brass Rod (Assortment): https://amzn.to/4bytrDc
Overture ASA (Green Sparkles): https://amzn.to/4bytrDc