Bird/Squirrel Feeder - Picnic Bench
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small Picnic Bench for all outdoor critters. Perfect Squirrel and Bird Feeder. Fits Smaller Print Beds. No assembly.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 158
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Squirrel/Bird Feeder - Picnic Bench
Perfect to mount onto a fence or tree. This design has a built-in rim around the table to fill with feed and includes drain slots on one end. The tabletop is at a very slight angle so that water can drain through the drain slots. Groves are built-in to the seats for better grip. Everything is designed to use minimal supports. No assembly required.
Flashforge AD5M(0.4 Nozzle), 220x220x220 print volume, Overture PETG
Print Time= 12hr 20min
Total Filament= 253.92g, 83.12m
Part is printed at an angle in order to fit on print bed, reduce the amount of supports used, and offers increased strength. I have tested and printed multiple PETG and PLA benches in various colors with no failed prints.
Print Instructions
Any settings not stated are left as default.
Layer Height: 0.2mm
Avoid crossing walls, Max detour length: 200mm
Wall printing order: Inner/Outer
Overhangs, Reverse on even: enabled
Wall Loops: 3
Infill: Adaptive Cubic, 6%
Speed: 50mm/s, first layer. 80mm/s, all other layers
Supports Enabled(Supports painted where needed, everything else removed):
Tree
On Build Plate Only
Top Z= 0.28mm
Bottom Z= 0.2mm
Top Interface Spacing= 0.1mm
Tip Diameter= 0.8mm
Branch Density= 20%
Tree Support Branch Angle= 45 degrees
Brim Type: Outer brim only
Brim Width= 7mm
Brim-object gap= 0.1mm