Galaxy S7 Edge Charging stand Choetech
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a charging stand i created for the Galaxy s7 edge, specifically for my Choetech standard wireless charger. I…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 123
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
This is a charging stand i created for the Galaxy s7 edge, specifically for my Choetech standard wireless charger.
I made this to have the cord going down strictly because of my dresser setup and the fact that my usb cords aren't quite long enough to go out the back.
You can remix this to make the charging cord go out the back if you like.
The choetech fits snugly into place and wont jar loose easily, the phone sits about 1mm above the plastic because of the rubber on the surface of the choetech to prevent sliding.
Works great.
Including an untested one for the cord going out the back side. Should work fine but i didnt print it for my use.
Here is a link to the charger: https://www.amazon.com/Wireless-Charger-Smart-Lighting-Sensor/dp/B013AB620C/ref=sr_1_11?ie=UTF8&qid=1480302659&sr=8-11&keywords=choetech+wireless+charger
Print Settings
Printer:
i3 mk2
Rafts:
No
Supports:
Yes
Resolution:
0.2mm
Infill:
20%
Notes:
This needs to be printed on its side, otherwise you're looking at 13 hrs vs 7.
Category: Mobile Phone