Orbiter V2.5 adapted Toolhead for Rook 2020 MK2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This toolhead now fits perfectly with Orbiter V2.5 for Rook 2020 MK2
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 52
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I stumbled upon an issue with the Orbiter V2.5 not fitting the original toolhead from Rook 2020 mk2 build. This model hopefully fixes all the issues I had with it. Hope it helps somebody else as well.
What was redone
the two main wholes with which the Orbiter attaches itself
also there was an issue with screws which was sticking out too much and the fit wasn't snug and screws basically touched Orbiter's motor, so I decided to add a bit of a recession for the screw heads to go into the filament slightly, it's only for 2mm but it worked, and now the Orbiter V2.5 fits perfectly