Phone Holder for Headboard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Specifically designed for BRIMNES Headboard to allow my S25 Ultra to be accessed and charged from headboard.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 144
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Share Alike
Specifically designed the clip to hold onto the below headboard from Ikea:
https://www.ikea.com/us/en/p/brimnes-headboard-with-storage-compartment-gray-50598389/
I made this with an open V design to allow access to the touch screen to swipe alarms off and made it shorter so my AOD display can show the clock without any obstructions. I also added a hole on the bottom to put my charging cable through.
I printed PLA with 4 walls and 25% Adaptive Cubic Infill on my Centauri Carbon
I print slower speeds to ensure structural integrity and have been getting good results:
First Layer 20mm/s
First Layer Infill 30mm/s
Outter/Inner Wall 125mm/s
Infill 200-250mm/s