Wired headphone clothing clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clip for hooking wired IEM headphones onto clothing. Easy to clip onto clothing and works with a variety of wire gauges.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 52
- Wydruki
- 0
- Wyświetlenia
- 149
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Yet another attempt at making a clip for hooking wired IEM headphones to your clothing.
I have tried so many other solutions, yet I had issues with all of them. Either they were incredibly annoying to hook unto clothing, didn't fit the thickness of the collars of my t-shirts etc., or couldn't hold onto the cables properly... So I gave up and made my own solution.
I made the clothing clip wide and flexible enough to fit unto thicker collars, and with a funnel-shaped opening to make it easier to put on. I have added an optional version for thinner clothing if needed.
The clip attaches to the cable(s) with a two-piece ratcheting slide mechanism. Lay the cable into the groove on the clothing clip. Moving from the arched section of the clothing clip towards the opening, slide the cable clamp down along the grooved section until it firmly secures the cable. Make sure the ramped section of the two parts are parallel to each other(insert the cable clamp with the thin section forward). Default version fits wire gauges of roughly ~1.2-2mm. A version for slightly thicker wires is included as well.
Printing:
Print in PETG. I cannot guarantee that the flexible parts of the clip and the ratchet mechanism work as intended in PLA. You could also possibly print them in resin, but I have not tested tolerances for that.
Layer height: 0.1mm
Infill: 100%
Support: On build plate only, only for the side of the ratchet mechanism on the clothing clip. Should easily break away if you pry it off with a blade between the side of the clothing clip and the support.
Brim: I recommend you turn it on as both parts have very little surface contact, but might be possible without. The clip comes with a little bridging line to prevent an "Outside only" brim from being generated inside the clothing clip. Simply cut it away when you remove the brim.