Easter Grave Ornament - Matt 28:6
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A standing ornament with a stone that rolls away.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 35
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
About the 3MF files:
The X1C_02 file uses a 0.2 to 0.3 mm nozzle to make the find detail on the text
The Snapmaker U1 file is the whole base which is 3 colors plus support (4 material).
The A1 file is all the parts that print separately out of the base material.
Assembly:
Break out the support material from the base. I found that the metal spatula (probably included with one of your printers) was good to punch through and separate the top and bottom supports from the base. Reach into the middle with a set of needle nose pliers and pull straight out.
If the Stone Center (the little nub) doesn't want to spin freely in the slider, push your pliers through the hole and rotate to open the hole slightly.
put the stone center int the slider and push the slider up through the base, There's a notch in the center that should give just enough room. Press the stone down onto the slider and it should lock in place.
The text, done on the 0.2mm nozzle will need to be pressed into the base. I found that I needed to use XY contour compensation of -0.08mm to get the perfect fit.
The stand fits in on the side with the slot. The slot is oriented vertically. If it doesn't press in, reprint with a bit of XY compensation. There's 2 holes so you can choose the angle that it sits at.
Filaments used in pictures:
Stone - Polymaker PLA Pro Wood Brown or Army Beige, or Gray
Sky - Polymaker PLA Pro Light Blue, Overture Digital Blue, Polymaker Translucent Cyan, Polymaker Luminous Blue
Black - Polymaker PLA Pro Black (any black will do)
White - Polymaker PLA Pro White (any non-translucent white will do)
Support - Polymaker support for PLA
Textures: If you don't use the 3MF files, the textures I use are Hilbert curve for the stone, Concentric for the cross and text, Octagonal spiral for the sky and grave.
Total cost is about $4