Precision Screwdriver Holder with Magnetic Base – 6-Piece Organizer

After the plastic base of my precision screwdriver set broke, I designed this 3D printed magnetic holder to keep my screwdrivers organized and secure instead of loose in my toolbox.

This holder uses two (2) neodymium magnets (cylindrical D10xH10mm) to keep each screwdriver firmly in position. I reused some old magnets I had lying around, and I recommend using grade 30 or lower – this makes the screwdrivers easy to remove when you need them, without sacrificing holding strength.

This holder was designed for Bremen precision screwdrivers (or similar brands with comparable geometry). As shown in the technical drawing, the cavities accommodate handles with approximately Ø14mm diameter and shafts of Ø3mm, with a total length of 180mm (80mm shaft). If your screwdriver set shares these dimensions, this holder should fit perfectly.  If your screwdrivers have similar dimensions, this holder should work great for you!

Also, this holder is designed for a 6-piece precision screwdriver set with the following specifications: PH00x50, PH0x50, PH1x50, PL2x50, PL2.5x50, and PL3x50.

Files included: STL files ready to print, and STEP files fully editable so you can customize the dimensions to fit your specific screwdriver set.

Important Notes:

• Magnet size: D10xH10mm (cylindrical neodymium)

• Recommended magnet grade: N30 or lower (easier separation)

• Magnets are inserted after printing – design includes cavities for press-fit installation

Feel free to remix and adapt this design to your needs. If you print it, I'd love to see a photo of your make! Happy printing! 🎉