Ice Scoop Holder for Vevor Ice Maker
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
It comes with an ice scoop, this adds a holder.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 40
- Wydruki
- 1
- Wyświetlenia
- 145
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
There we were, ice maker running, scoop a-flying with no landing spot in site. We used a tea mug for awhile. The mug had a mind of its own and we’d find it in strange places.
This scoop holster attaches with magnets. Scoop fits in it and it has holes for ventilation and drainage. Not sure what else to say about it.
Printing Instructions:
I used a 0.6 nozzle and .32 layer height. But all the walls and tolerances are big enough you should be able to use most anything.
No supports
I used 15% gyroid infill. Feel free to try something else.
Please use a food-contact safe filament.
Needs:
PETG or another filament you trust for food surfaces.
Four 12x3mm (n52) neodymium magnets
Superglue
Post Process:
Superglue magnets in. Note: they stick out a tiny bit. This is intentional so it’s easy to angle the holder and pull it off.
Wait for the glue to dry.
Wash with dish soap and water. Don’t be a dirty.
Wait for it to dry, or dry it with a kitchen towel.
Find a position on the ice maker that you think would be easy to grab the scoop and holster it back.
Place holder with the magnet side on the ice maker’s metal side where you want it.
Holster the scoop.
Enjoy!