Mount for Arctis Pro Wireless base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
Fairly simple part, settings vary between printer and slicer software and material. For this bracket I got really good results for the resolution and settings listed as well as a nozzle bed temp at 220/60c (Cura slicer 4.13.1). This bracket is designed to use button head screws of 1/4-20 size (#14 wood screws). For length sizing, the button head seat to desk is .25" thick + 1/2 desk thickness (no less than .25" for decent thread grip).
This is the third revision for this part from the original shown in the picture. Then only changes were wall taper angle (from 2 degrees to 2.5 degrees) and the rear wall sections being tapered and adding a radius for the corners to "hug" the base better. Open to any suggestions if there is a fitment issue, please leave a comment. Thank you! Hope you enjoy!
Installation - The base must be slid in from the front, do not try inserting from the top!