FTN 5 Suppressor Wrench smol 1/2 inch drive
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I took out the random hole in the middle of the small one and put in a 1/2 drive hole to make it kinda like a crows foot
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 82
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Public Domain
So mine took way too much force to screw in so I printed this in PLA+ (not even the good stuff it was like deeplee rapid PLA+ run at 200 mm/s) and it held up to being torqued on by a like 3 or 4 foot breaker bar in a vise, so if youre having a hell of a time screwing in the insert this might help. 1/2 inch breaker bar socket, most commonly found in breaker bars for wheel lug nuts. Mine printed a touch tight but I didnt modify anything other than the hole in the middle so maybe scale it up just a little bit if it does that to you? But everything still fit.