Playseat challenge X frame reinforcment kit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Reduces wobble by restricting pivot joint movement.
- Ocena
- 5 / 5
- Polubienia
- 0
- Pobrania
- 29
- Wydruki
- 1
- Wyświetlenia
- 351
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
With this mod you will not be able to use pivot joint to open up the frame, you will need step over into the seat.
I suggest you print it at a slant, like on screenshot. Also, use most creep-resistant material you have. More perimeters -> more strength :) Don't overtighten screws, tighten in criss-cross pattern, requires screw tightening with time because of creep. You might need to get rid of "playseat" debossing on he plastic part, I used utility knife to remove it.
Required hardware:
M4*20mm inner-hex bolts or pan-head screws (6 pcs)
M4 nut (6 pcs)
M4 washer (optional) (6 pcs)
Based on the one from "challenge-bob" which he sells for 30$.