1 / 4
Blokees Minions Mokoo Skeleton Armature Replacement — zdjęcie 1
1 / 4

Blokees Minions Mokoo Skeleton Armature Replacement

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement ribcage and pelvis skeleton parts to build both the full Skeleton AND the Minion figure at the same time.

Ocena
0 / 5
Polubienia
2
Pobrania
10
Wydruki
0
Wyświetlenia
156
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

These parts can be used to build the internal ribcage and pelvis/hips for Blokees Mokoo Minions figures. This allows you to assemble both the skeleton and the full Minion figure at the same time and keep both displayed! 

UPDATE 3-22-2026: Added Ribcage with Head Top and Head Connector parts. These alternate parts let you replace the Ribcage with a ball joint for the head in case your originals break or get lost. Also added Ribcage Bottom Bob, which is 1mm shorter to match the smaller Bob figure. All other figures (Kevin, Dave, Stuart, Tim, Phil) use the same Ribcage Bottom part.

Print all parts as oriented. No supports needed. You might need a brim for the Connector piece. Print at 0.15mm or 0.10mm layer height for smoothest details on the ball joints. PETG is recommended to prevent the parts from becoming brittle over time, but PLA +/Pro should also work reasonably well.

The Ribcage Bottom and Ribcage Top have two smaller holes for pieces of 1.75mm filament for proper alignment. Glue Ribcage pieces together, but not the Ribcage to Pelvis parts. Those should remain unglued to swivel slightly.

If printing the Head parts, attach the Pelvis Connector to the Pelvis piece first, then the Ribcage. Then insert the Head Connector last to ensure everything pushes together fully.

Tagi