Seat Leon 1P 17 cm Speaker Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter to fit 17cm speakers to a Seat Leon 1P, might fit other models als well
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 172
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
Here is an adapter ring to fit 17cm (6,7") speakers at the same hight as the original in a Seat Leon 1P 2010 - 2012, might fit other models as well.
It was made to fit Pioneer TS-G1730F speakers, but shoud fit other speakers with 158 mm hole pattern.
It is a two piece design, so you dont need supports.
Simply glue them together with super glue using the aligment marks.
I also added a one piece version.
On the top, there is a gap to route the cable outside, to use the origintal plug with an adapter cable.
I would recommend to stick a 1mm foam sheet to the top and bottom faces to isolate and seal the speaker.
Mounting:
Fist, screw the adapter ring into the door using the original holes and screws.
Plug in the cable to the speaker, route the cable outside.
Then use the screws supplied with the speaker (optionally with washers) to mount them to the adapter.
You can fit the speakers also without the adapter ring, but then it sits 30mm lower than the original under the grill.
Made to replace original Seat 1PO 035 411 speakers.
Print with 4 walls and 20-30 % infill. I used 0,24mm layer hight.
Feel free to remix!