1 / 3
French cleat print bed plate holder/organizer — zdjęcie 1
1 / 3

French cleat print bed plate holder/organizer

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

French cleat print bed plate holder/organizer

Ocena
0 / 5
Polubienia
6
Pobrania
10
Wydruki
0
Wyświetlenia
94
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Simple and filament-efficient print bed holder. Only uses ~150 g of filament.

Parts to print
  • Print two of the holder parts, remembering to mirror one of them. The one as shown will be the used for the right-side, and its mirror will be your left-side part.

  • Your will also need at least one of the connectors, although I recommend that you use two. The one included is 218 mm long. Scale it longitudinally to whatever size print bed you have.

    • Even though the print bed dimensions are larger than the max printing area (e.g., ~235x235 mm for a 3D printer with 220x220 mm printing area), simply matching the maximum length of your printing area will be sufficient.

    • However, if you prefer, you can print the connectors diagonally and scale them to match the actual dimensions of your print bed.

  • Lastly, if your cleat spacing is to wide or need to place the holder in a location where the lower section of the holders will be unsupported, you can print two support spacers/stand-offs (see third photo).

Assembly

I recommend that you super glue the support spacers first. Then, insert the bottom and top connectors into the triangular section of the parts to connect the left and right sides (see second photo). That should, hopefully, be a friction fit. The goal is to have an uniform spacing on the top and bottom so that the places go in easily and yet don't have too may play. Remember that you may only be able to insert about one inch on each side. Add a couple drops of super glue if you didn't get a good friction fit or simply want to make it more secure.

Tagi