1 / 7

BLE CaberQU USB Cable Tester - alternative case

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

An alternative case for a fantastic USB cable testing device from CaberQU: the BLE caberQU https://caberqu.com/

Aktualizacja u źródła: 24 mar 2026

Informacje o modelu

There is this fantastic USB cable testing device from CaberQU that can be found here: https://caberqu.com/ -> BLE caberQU

This is an alternative case version to print yourself. You can buy the PCB and screen spare part and pack it into this case.

You will need:

Get PCB and LCD here (under spare parts)
https://caberqu.com/
Look for BLE CaberQU

Acryl Sheet:
https://s.click.aliexpress.com/e/_c42Y3Wgb
https://s.click.aliexpress.com/e/_c4LOSUwr
(very simple to size: make 1 deep cut with cutter, aling on edge, fixate the top, break.

Note: The markings on the cover are painted on in the slicer and not part of the STL. If you do not paint them yourself, the print will be blank.

Note: The standard wall (1.5mm) might be too tight for the PCB. In this case please use the thin wall STL with 1.35mm.

Instruction: (see pictures)

Open the LCD connector latch on the PCB, remove LCD - yes, latch, do not just pull it out!
Insert PCB into case - depending on your printer it should fit very tight. Check orientation!
Insert buttons into Block
Insert Acryl sheet
Insert LCD screen
Insert LCD lock plate
Screew on Button Block (carefull, they might fall out...)
Put a sticker on the outside to hold the buttons

Now you are ready to merge the two parts.

Put the base on the table
Connect LCD
Close it
Power it up to veryfy if LCD works
Insert screws, do not tighten
Rotate it so the side with the power connector faces UP and the screen towards you
Open it slightly, SHIFT panel to the right, insert spacers
Now fold it open to insert spacers on the right
Tighten Screws
Remove Tape

Done - happy testing!