Voron 2.4 Z-belt retainer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These are to retain z-belts prior of gantry detaching. Keeps z-belts on their pulleys, prevent sliding/rolling
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 146
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
These retainers are for keeping belts on their pulleys, preventing sliging or rolling. So when you're about to put your gantry back on - belts will wait for you right as you left them.
Made of 2 parts: base and lid.
You can go on with only base part, as i have found belts to sit pretty firmly inside slots. Print also a lid part if you don't feel lucky. Lid will latch around the base, retaining belts to slide out of slots.
You might want to print lid in 2 perimeters without bottom/top walls at all to make it springy.
MULTIBODY PARTS:
I have added some extra bodies to the parts. You can always use slicer to split part to bodies to manipulate them.
There are support bodies in the LID file (which you can remove by splitting object to parts) to help you print it in the right orientation (on it's side)
There are hole bodies in both parts - you can set them to "negative volume" to make threaded M3 holes both in base and lid.
Target belt is GT2/9mm, mentioning just for a case