InstaCrate to Ridgid Pro Gear 2.0 adapter feet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter for collapsible InstaCrate (found at Costco) into the Ridgid 2.0 Pro Gear
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 437
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I couldn't find the Ridgid crate, so I used my collapsible Costco crate on top of the Ridgid 2.0 two-wheel dolly. But it slid around, a lot. So, Tada!
It isn't fully locked down, but from the back seat to the front door on the dolly it's more than fine. This set of 5 feet can be glued to the bottom of the crate (E- 6000 or similar), and allow it to lock into any of the 2.0 Pro Gear combinations. The middle foot is intended to support the bottom of the crate when it's not part of the set but is also designed to fit into the gap on Pro Gear lids where the handle is, or even between 2 of the 2.0 Small Parts Organizers when they are sideways mounted.
The center foot also has holes for magnets in case you want to make it removable, though I haven't found a combination where that's an issue. Note it is beveled along the short axis of the crate to allow it to fit between 2 Small Parts Organizers if that's what you have on top.
Note the real Pro Gear crate is far sturdier than this flimsy Costco thing. But if you are doing light-duty transport and not throwing things like power tools or hammers into it, it should be okay.
