Ultimate Glove Dryer (No Supports!)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The ultimate glove drying rack for your heat register. Fits a standard 10"x3" opening.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 105
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- GNU General Public License v3.0
Our 4 kids come home with wet gear every day in the winter, and we needed a better way to dry everything. Previously we would take various register covers off and stuff gloves into the openings. This is a much neater, over-engineered solution to that problem!
All of the parts can be printed without supports. The base should be printed top down, and the top should be printed top up. The tubes are to be printed standing up, and I recommend an inner brim for safety. Outer brim requires post processing so avoid that.
I've provided the full size and split STLs. My printer is too small to do it in one shot so the parts have to be glued together with CA. In either case the tubes are to be glued into the counterbores with CA.
There are two tube designs, dryertube is 1.5mm thick, and DryertubeThick is 2.5mm thick.
Sand and paint if you want to hide the seam on the split version. I printed mine in PLA, this should be fine unless your register is putting out very hot air, in which case you might want to try PETG.