K-9 Model Rocket Landing Leg System V6
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
K-9 Landing Leg system is a model rocket landing leg system designed to soften the final impact
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 288
- Wydruki
- 0
- Wyświetlenia
- 1378
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Engineering
- Licencja
- Creative Commons — Attribution — Noncommercial
K-9 Landing Leg system is an open source landing leg system designed to soften impact at landing, and keep your vehicle upright. I have gotten numerous requests for these files, and after a lot of testing and redesign, it is finally out! The system is capable of withstanding impacts from 1-2 meters. Our tested data showed 25 feet or 7.62, but that's pushing it to the absolute limit. It deploys by any band around the leg being cut with nichrome wire. The deployment is controlled by the pyro output of your rockets flight computer. This system is designed to work with 3 inch air frames or mailing tubes. Hope you like it!
website: https://caninerockettech.wixsite.com/rocket
Youtube video: https://www.youtube.com/watch?v=WrCgBvL1J0s
Disclaimer: ROCKETRY IS DANGEROUS, USE ANY ROCKETRY COMPONENTS, 3D PRINTS, AND FILES BY Canine Rocket Technologies AT YOUR OWN RISK!
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
Yes
Resolution:
0.1
Infill:
25%
Filament: Inland PLA Grey
Notes:
Compatible with M3.5, M4, or #8-32x1/2 in machine screws. If using M4 or #8-32, drill all holes with 3.8 mm drill bit.
To spring load, use any normal rubber band. Try to use an even amount of wraps and bands on each leg for consistent deployment.