Starseeker E55 Coffee Grinder Portafilter Holder

Portafilter holder to be mounted on the Starseeker E55 to grind straight into the portafilter. The model fits multiple versions of the 58 mm E61 standard (depending on the diameter of the out portafilter). The model still allows for the original cup to be used (as seen on the images) and allows for a portafilter with a dosing ring ontop of it to fit as well (as seen on the images). The portafilter is slid into the holder with a 2.5 degree angle to prevent the portafilter to slide out. 

The model should be printed PETG or ASA (as I've done in the attached pictures) and NOT PLA since its too brittle. The model should be printed in its default imported position, as this results in the strongest option. The model should be printed with the following minium settings:

• ABS or PETG

• 0.15 mm or lower layer height

• 0.4 mm wall thickness

• 6 walls

• 6 top

• 5 bottom

• 30% infill 

• Support Enabled (will only be applied on non-visible areas)

• OPTIONAL outer brim depending on (warp prone) material choice

The model is fastened using 2 M5x16 Button Head or Low Profile Head screws in the original mounting holes.

The .step files are attached to allow for customisation of the model.