Water filtration through a Brita Maxtra PRO cartridge
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Water filtration through a brita cartridge, for an aquarium (reducing water hardness and removing chlorine).
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 128
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution
The device is used to filter water using filter cartridges from Brita. I use the Brita maxtra pro cartridge, which is designed for extremely hard water. The hardness of the water will not be completely removed, but it will greatly reduce it + remove the chorus from the water. One cartridge can filter 150L of water. I use 10L buckets from Bauhaus.
1) A hole with the inner diameter of the large seal is cut into the bucket (I use 10L buckets from Bauhaus.).

2) According to the template for small and large seals, I cut out seals from 4mm rubber (preferably silicone) or I print the seals from TPU.

3) Insert the small seal into the base followed by the filter cartridge (see picture)

4) I tighten the flange using the printed screws. There are spacers inserted between the flange and the base, which serve as spacers.

5) Insert a large gasket from the underside of the base.

6) I put the base into the bucket and secure it with a nut on the other side. Be careful, there must be a seal between the base and the bottom of the bucket with a minimum thickness of 2mm (better 3-4mm)

7) I will put 3 bucket holders on the second bucket. I recommend printing one holder and testing to see if it fits your bucket..


8)Then I place the bucket with the filter device on the bucket equipped with bucket holders. Pay attention to the diameter of the bucket so that the handles are large enough. Then I fill the large bucket with water and wait for the result.
