V-tail Frame for the Hubsan X4 Quadcopter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
V-Tail quad-copter frame using the Hubsan X4 board. All motors were upgraded to 8.5mm coreless motors. It has a very…
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 446
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
V-Tail quad-copter frame using the Hubsan X4 board. All motors were upgraded to 8.5mm coreless motors. It has a very sharp and responsive Yaw control.
Stock props can provide enough lift but only at 80% throttle. Exchanging the back stock props with bigger ones will improve the performance. My current setup is listed below:
- Front prop: Stock props
- Back prop: YD717 props
- Board mounts from the bottom of the frame
- Back motor wires may need to be extended to reach the board
Additional Information:
- Tilted (dihedral) front motors: 5° to the center
- Front wing angle: 150°
- V-tail angle: 120°
Print Settings
Rafts:
No
Supports:
Yes
Infill:
30%
Notes:
PET+ works the best for it's durability and can survive the most intense crashes.
ABS and PLA can work but can't survive that many crashesV-tail legs need to be printed separately and glued to the bottom of the frame.
Post-Printing
Category: R/C Vehicles