Ecovacs X11 / Yeedi S20 - Internal Tank Refill & Hydraulic Tester (Anti-Dry-Mopping Tool print with TPU)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Diagnostic tool for Ecovacs X11 / Yeedi S20. Manual refill adapter to prove software logic bugs & fix dry mopping.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 105
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The Problem: Many X11/S20 units fail to trigger the internal pump while docking, leading to a bone-dry internal tank despite the station being full.
The Solution: This 3D-printed adapter fits into the water intake port of the robot.
How to use:
Attach a standard syringe (without needle) to the adapter.
Gently inject water until you see a controlled overflow from the drainage port next to the mop rollers.
If you can inject ~110ml, your hardware is 100% OK.
Safety Note: Do not use excessive pressure. This tool is for diagnostic purposes and to prove firmware-related refill failures to support teams.
Recommended Print Settings:
Material: Flexible TPU (95A Shore hardness) is highly recommended for a watertight seal.
Filament Specs: 1.75 mm (Transparent used in prototype).
Walls: 3-4 perimeters for pressure resistance.
Infill: 15-20% (Gyroid recommended).
Resolution: 0.15mm or 0.2mm for smooth sealing surfaces.
Why TPU?
The 95A hardness provides the necessary flexibility to snap into the robot's intake port without damaging the plastic, ensuring no water leaks during the manual 110ml injection test.
