AR15 Upper and Lower Receiver Spray Paint Masks
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
masks to make painting your receivers a bit easier. No more blue painter's tape
- Ocena
- 5 / 5
- Polubienia
- 159
- Pobrania
- 420
- Wydruki
- 0
- Wyświetlenia
- 3644
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
Every time I build a new AR, I typically paint the receiver set. I have always just used blue painter's tape. But I decided to make it a bit easier. I made some 3D printed masking inserts. I even added holes on the ends to hang them from a wire to so I don't spray my fingers and to hang them in the shop to dry/cure. I typically use either Brownells Aluma-Hyde or Rapco rattle cans.
There are a few screws used to hold the assemblies together. I made the holes to accommodate 3mm screws, because most people with printers have a plethora of extra 3mm screws in a parts box. The forward assist and trigger guard pieces are held in by just a small length of 1.75mm filament. adjust as you see fit. I included STEP files to make it easier for anyone to use/mod them. I also made a second version of the lower main mask. It is for if you strip down a lower that is already built and don't want to bother with tapping out the pin to remove the bolt release ping pong paddle. I think that's it. Enjoy! Prosper!