1 / 2
LiPo 18650 Battery Case/Pack 12V BMS 6 Cell — zdjęcie 1
1 / 2

LiPo 18650 Battery Case/Pack 12V BMS 6 Cell

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple Battery case/shell designed for 18650 cells, for general use

Ocena
0 / 5
Polubienia
3
Pobrania
22
Wydruki
0
Wyświetlenia
174
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Basically, I'm an electronics hoarder/salvager and during the past months have gone through years of collected battery packs and used vapes. I couldn't find a case in such a flat style as i need to carry the bank with me in my pants so i made this to use for different 12v applications.

For assembly, i used brackets designed by @jonnieZG to set up a 6x1 array in cell pairs of two, then soldered a standard 12.6v 3S 20A BMS module to the cells and taped with kapton tape. I noticed in the first prototype that the seem didn't quite close properly so i added a insert notch around the two halvs which should also lock in place. and finally a small hole to feed out a dc jack connected to the BMS output.

MAKE SURE THE DC CABLE IS THICK ENOUGH TO SLIGHTLY PINCH IN PLACE, to avoid ripping the whole BMS pads out. Also excuse the paper towel at the bottom, i used it to secure the battery array in place because of thick wires used to connect it, this can be avoided by using proper nickel strips and scaling down the final print (the proportions should be accurate).

Pretty simple so enjoy. Some supports needed for clips and overhangs but otherwise printer friendly.

The design can theoretically be made THicker or longer to house more cells and a more powerful BMS.

The BMS module that i used.

@jonnieZG 18650 Battery Modular Bracket - 

Tagi