Minimal Book Rest with Glasses/Bookmark/Device Storage
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My take on a book rest with storage options.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 43
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
This is one of my first designs, so feedback is appreciated :)
I made this as a gift and thought I would share. No supports or screws needed! Only a little super glue to secure the pads to the pillars.
The tolerance for the pillars and glasses hook is pretty snug. The pillars shouldn't need any glue. You will want to use some super glue to secure the rest pads to the top of the pillars though.
The protrusion/notch at the bottom of the pillars will face inward, and there is a small bevel on the bottom outward edge to allow them to be slotted into the base at a slight angle. Takes a decent shove but should snap in solid!
The reading glass hook should fit snugly into the slot on the right-hand wedge as well. I used a couple of drops of super glue just to be safe, but the couple I've printed didn't seem to need it.
There is a slot between the pillars designed for phone/devices, and four 12mm x 2mm holes on the bottom for some 3M rubber grip pads I had around. The opening of the bookmark slot is 48mm x 3.8mm.
I also made a bookmark and a winged page holder to go with this design.
Here are a few notes/settings I used to print on my FlashForge AD5M:
0.20mm Standard @Flashforge AD5M 0.4 Nozzle
Book Rest Body:
Sparse Infill density = 12.5%
Glasses hook:
Spares Infill Density = 20%
Page holder note:
Print with 3 walls- on my printer at least this helped with issues on the outside
Bookmark Note - Settings to make the bookmark 2-toned:
Layer height: 0.08
First layer height 0.24
Change color at layer 18