Bird Party Masks
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed for use in a costume ball or masquerade, these masks are small, lightweight, and packed with great texture!
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 93
- Wydruki
- 0
- Wyświetlenia
- 267
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Masks
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Designed for use in a costume ball or masquerade, these masks are small, lightweight, and packed with great surface textures that show up even at 0.20mm layer height!
Printed using Bambulab Glow in the Dark PLA.
Please be aware that, due to the required printing size to make a wearable mask, this model is not suitable for an A1 mini.
Wearing the mask
Holes for threading straps are found on the sides.
The thicker the cord/strap, the better support you'll have keeping the mask on.
The mask was sculpted over a standard styrofoam mannequin head model (Find it below) which makes the mask suitable for most adults to wear, but in the provided RAW STL files, they are small (best suited for kids). If you want them to fit a large adult, I recommend scaling them up by 10-15% if you're not using my 3MF file.
Head model used as reference: https://cults3d.com/en/3d-model/art/mannequin-head-full-size
Print Set-up
Supports are required to print the mask; without them, the mask will not print well, if at all.
If you plan on using the RAW STL's and not my 3MF file, please follow the instructions below:
Turn supports ON.
Set the type to “Tree - Auto”.
Set the style to “Organic”.
The threshold angle should be unchanged (the default is 25/30).
Tick the “on build plate only” box.
Note that sometimes the auto-generation may fail to add supports to the eyes or the rim of the forehead. The mask will print still, but you may get 'looping' that will require you to sand them down.
Using a brim is optional, but is highly recommended, as the mask profile is narrow, it is at risk of coming off the hotbed without the brim.
As always, I recommend printing them in matte white, spray-painting them with a primer, then painting them by hand.
NOTE: The 3mf provided was made in Bambu Studio and may not open in other slicers. Please use the raw STL's if the 3MF doesn't open. I am not responsible for other peoples' print profiles.
This file covers personal, non-commercial use; do not share or redistribute without attribution. Do not sell the files or prints of the files. Remixing is allowed but again providing attribution is required. Do not remove the creator stamp.
If you want to sell prints of this model, please visit my Patreon and subscribe to the correct tier to obtain a Commercial License: https://www.patreon.com/thomastedwards