Suzuki Bandit throttle cable holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement throttle cable holder for Suzuki Bandit 600
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 114
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
The metal plate which normally takes care of fixing the throttle cables can crack in it's mounting point on the carburetor. This is very hard to repair, so this plate is an alternative mounting point for the two throttle cables. It mounts between Carb 2-3 on top of the CV diaphragm dome.
Updated version:
Thicker plate (6mm vs 3.20mm)
+10 and -10 degree angles for both throttle cables mating surfaces like the stock bracket
Edge chamfers
Non printable parts required:
4 x M4 x 22mm - 25mm machine screws
4 x M4 washers (recommended, not necessarily needed)
Material choice:
I printed this in PETG. PLA is not recommended due to temperature. I have not tried PLA but the part sits relatively close to the cylinders.
Mounting instructions:
Print 4 bushings and 1 plate. The bushings support the diaphragm dome mounting holes, fit them on the screws before mounting.
Be gentle to the diaphragm dome while it's missing two screws during installation. I did not experience any problems, but I guess you could risk misaligning the diaphragm.
General information:
This part is related to the throttle, so be very careful that it doesn't stick and that the cable runs smooth and correctly when using this bracket.