Multifunction Arm mounting system
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
It is a set of holders for hanging or standing monitor, notebook or any other devices.
- Ocena
- 4,87 / 5
- Polubienia
- 12 812
- Pobrania
- 25 885
- Wydruki
- 198
- Wyświetlenia
- 206 052
- Oceny
- 184
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
Arm mounting system
- Added source file of basic arm - parametric (you can see the process of drawing teeth) (f3d)
- Added source file for bolts and nut (f3d, stl)
It is a universal set of holders and arms. You can use this system as a notebook holder, tablet holder, monitor holder, camera or any other device holder or you can have it as a shelf holder.
If you print a pair, you can made various tables.
You can attach more arms togehter. I made some connecting parts and other accessories.
There are no limits to imagination.
I made it with increased strength and durability. If you add few perimeters the holders/arms can hold pretty good weight.
Small light version
Holders reduced x 0.6 and then adjusted (hole sizes, gaps, etc.)
Základní informace
|
You can adjust the angle in ten degrees. Screw and nut fit on both sides.
|
| You can tight and loose from both sides no matter where the nut is. |  |
 | There are various nuts and screws. Of of them counts with the allen screw (hex bolt) M8x40
|
| You can also print the crew which can be tight and loose without gear- with the printed hex bolt screw. |  |
  | The holes for key in the screw and two arms have the same size as the holders in Honeycomb storage wall (https://www.printables.com/cs/model/152592-honeycomb-storage-wall). That means that you can hang different accessories on the arms.
|
| There are various of arms. |  |
 | Clamp I made 3 different types -
|
 | VESA rotating holder - 75mm |
Combination for possitioning along the axis Z 
| System - high table for tablet holder
|
 | There are holders for three tablets. Bottom width
screw spacing 30mm |
Basic arms
The only difference is the grid
Holders
A few basic handles
I printed small parts on the Prusa Mini, the arms on the Ender 3.
Small arms size
My printing settings
- material: PETG
- perimeters: 8 and more
- infill : 30% and more
- layer height 0.3 (with nozzle 0.6 layer height 0.4) (screw and nuts only 0.2mm layer height)