Hole plug with tight seal for sheet metal. 40mm (mk4 vw body panel blind plugs)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
40mm plug for thin material, 1-2mm/18-12ga. Over-engineered for better seal on both inner and outer surfaces.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 94
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Needed burly plugs for the spare wheel pan and other undercarriage holes of my mk4 golf tdi. In the spare wheel pan, the original ones were installed from above, so I made them similar. I wanted the flange that goes through the hole to really seal against the bottom surface, rather than just being a sort of bump that holds the plug in place. Designed so you really have to really fight the thing to mash it in, but that means the outer rim and inner flange are loaded against each other, and really press against the surfaces. Whether this makes a better seal, or just traps more dirt and water... time will tell. but with 23 years and 240k miles on this thing, I'm willing to gamble a little to keep water and mice out of my car.
Takes some massaging to get it into the hole, once you get one side pushed down, keep pressure in the middle and work your way around the edge, pushing down on that outer arch.
Oval plugs and 13mm plugs for the rest of the holes in this car will be uploaded soon.
print as solid as you can with 85a. I had to use lots of top layers, rather than walls or infill, just to get orca to bridge that outer arch correctly (I can probably redesign to fix that, but after 9 revisions, I'm over it..). haven't tested with standard 95a tpu, maybe just use 2 walls and 50% infill for 95a?
