1 / 4
R7 Pastry Vault – The Tactical Toaster Pastry Case | R7Makers — zdjęcie 1
1 / 4

R7 Pastry Vault – The Tactical Toaster Pastry Case | R7Makers

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The R7 Pastry Vault is a rugged, pocket-sized container to keep your pastry snug and protected.

Ocena
0 / 5
Polubienia
7
Pobrania
11
Wydruki
0
Wyświetlenia
44
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

🧇 R7 Pastry Vault – The Tactical Toaster Pastry Case

Stop the Breakfast Carnage. This crush‑proof 3D printed case is designed to carry a standard foil‑wrapped toaster pastry in a backpack, diaper bag, gig bag, or EDC kit without ending up with a pile of crumbs.

The R7 Pastry Vault is a rugged, pocket-sized container built on the same architecture as the R7 Vault Wallet, but with tight internal clearances to keep your pastry snug and protected. It is designed specifically for 3D printing and includes details that make it fun to print and fun to use.

✨ Features

  • Crush-Proof Protection: Custom-sized for standard foil-wrapped toaster pastries.

  • Magnetic Snap: Uses the same 9x3mm magnets as the R7 Minimalist Wallet for a satisfying, secure "clunk."

  • Filament Hinge: Uses a standard 1.75mm filament pin for a nearly indestructible, low-profile hinge.

  • Pro Aesthetic: Designed for multi-color printing to get that iconic "frosted & sprinkled" look right on the build plate.

🎯 Who It’s For

  • 🧒 Toddler Parents who need an “emergency snack” that survives the diaper bag.

  • 🥾 EDC and Outdoor Enthusiasts who want a tactical, fun way to carry breakfast on the trail or commute.

  • 🎁 Gift-givers looking for a hilarious but actually useful present for the toaster pastry addict in their life.

📦 Hardware Needed

⚙ Print Settings (Recommended)

  • Orientation: Print both halves "face-down" for the smoothest finish on the graphics.

  • Material: PLA, PETG, or ASA.

  • Layer Height: 0.2 mm.

  • Walls/Infill: 3 walls for hinge strength; 15% gyroid infill.

  • Supports: None Required! ❌

🛑Important Note

While this vault protects your breakfast, 3D-printed plastics are generally not certified food-safe. Keep your pastry in its original foil wrapper to ensure it stays fresh and safe to eat!

💵 Want to keep your money safe too?

Check out:

💼 Want to Sell Prints?

Get full commercial rights and monthly drops:

👉 Join the R7Makers Membership


Tagi