Spray Paint Can Shaker
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I printed another design like this, but it fell apart quite quickly.I took inspiration from that design and created…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 69
- Wydruki
- 0
- Wyświetlenia
- 331
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Share Alike
I printed another design like this, but it fell apart quite quickly.
I took inspiration from that design and created this model that is a little more sturdy. I also printed in it in PETG for increased strength.
The cans that I need to shake are parking lot striping paint so they are longer and heavier than an average can of spray paint.
With the original I used a metal hose clamp tightened around the can. The metal edge of the clamp was the the failure point on the test model. With this model I created two strap hold down points to spread the stress. In hindsight i should have only drilled one hole through the saw blade. Hardened steel is quite difficult to get through.
I shook 4 cans on a low speed and it seemed to work well.
Category: Outdoor & Garden