AlzaErgo F240B VESA Mount Enforcer

This "VESA Mount Enforcer" has a specific usage in this case. There are no extra holes to mount to the wall.

I've bought two AlzaErgo F240B Super Slim VESA mounts to mount two of my miniPCs (HP terminals) to the side of my table. Since the side of my desk is not very thick, I've decided to stick it to the table with double-sided nano tape. These tapes are strong as hell until you wiggle with them. These VESA mounts are designed to be mounted at the center, which is a problem in my case. Even when my miniPCs are not heavy, when I connect cables to them, the cables have a tendency to pull the miniPC to one side. This is causing the whole mount to tilt to one side, and the double-sided tape is unsticking because it is mounted at the center. 

These enforcers are designed to be mounted to the VESA 200x200 holes of the VESA mount and enlarge the base of the mount. Also, they are providing more space to stick double-sided tape.

Why am I mentioning one particular model of VESA mount when VESA is standard? Well.. Because my "Mount Enforcers" were made for the exact distance of the surface - 1,2.

Holes to mount my enforcer to the VESA mount have a 54mm diameter, so you can use the screw already included in the VESA mount box (M6 screws from the "MC" marked bag). There is NO THREAD in the holes. It is on purpose. I've done holes a little bit smaller than an M6 screw, so the screw can make the thread itself. It helps the connection to be stiffer.

There is also a cutout on the top side, which allows you to reach the "securing" screw at the top side of the center mount point (so be careful with the orientation).

Finally, why am I even uploading the model when it was created for such a specific reason? Maybe there is someone who is dealing with the same thing. Maybe someone will find it useful for another case.

I recommend printing it with 100% filling with gyroid pattern and 0,2 layer height