1 / 4
Filament roll adapter for rolls with all hole diamteres — zdjęcie 1
1 / 4

Filament roll adapter for rolls with all hole diamteres

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adapter for filament rolls with all hole diameters. For Snapmaker U1/Bambulab printers with spring loaded spool holders.

Ocena
0 / 5
Polubienia
4
Pobrania
22
Wydruki
0
Wyświetlenia
129
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This is an adapter for the spring loaded filament roll holders used on the Snapmaker U1 or most Bambulab printers.
I found that filament rolls were very hard to take off of my Snapmaker U1, so I made this roll adapter to make the process easier. It simply slides on the existing holders (though a bit of force is required). The clip to hold the roll in place can be easily attached or removed by pressing it together at the arrow marks. I also made a spring to allow the RFID chip to stay close to the printer. This is simply put inbetween the spool and the clip.
Since I dont own a Bambulab printer, I cannot test wether the holder perfectly fits on one, but I think the Snapmaker U1 uses the same system for its holders, so it should work. The model is scaleable in case.

Filament: eSun PLA
Settings: no supports, layer height 0.2mm,