RAKTastic! (V1)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a slim profile case for a RAK 4630 Meshtastic kit and 3000mah battery.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 136
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
Simple case for a Meshtastic node using the RAK 4630 / 4631 starter kit (with flat LoRa antenna). Signal strength isn't great with this little antenna, but it's slim and convenient to slip into a pocket or bag. It'll run for over a week on a single charge with a 3000mah battery.
When it comes off the print bed, the lid will be very tight sliding into the case. Carefully slide it halfway on and off a few times and the two parts will begin slide together much easier. No glue or screws needed, as it's all a tight fit (depending on the switch you use, you may need a dab of hot glue to hold it in place).
NOTE- You will have to solder the battery leads directly to the RAK board. The JST connector is too large for the cover to slide on otherwise. Just remove the JST connector on the RAK with a soldering iron and connect the battery leads directly to the board (triple check your positive/negative orientation). This case provides a slot for an on/off switch, though it's not required.