gorgeous satyr

I posed this beautiful creature on my luminous hand,I realise this is not for everyone so I made her separate, so that you may chose what you want to do with her.

I am going to make a colour model tomorrow and I shall add that to the pix when it is finished..

with tree supports, 4 wall loops and 20% infill she is quite sturdy and her fingers did not come off with the supports.

I always use PLA filament because I have the settings stable on my ankermake m5c....

my cellphone camera is really a rotten critic.She looks much nicer to the naked eye (and I printed her too fast).

I decided that I like this model so much that I am going to hang her on the wall in the bathroom....

so I have added a wall mount in case anyone is interested....

I made her 180% bigger (180mm tall) so the mount is x 168mm y.138mm and z 100 mm ... this gives her room to comfortably kneel on the wall mount

Cor! Here is a tip....

I decided that the wall mount could be printed on fast mode. After it printed the first few layers,I thought, wait a moment. This is a perfect opportunity to use up a load of my remnant spools with only 1-4 metres filament on them....

Ha! As it was zooming along when there was 2cm sticking out of the extruder, i put the printer on pause,retract, new spool, extrude and then continue....

I used up 5 remnant spools in 45 minutes. Far better than  nancying about with those filament splicer jobbies.... Yay! Room for 5 new spools on the rack.... and it came out well smart...