SpeedyBee Master 3X Walksnail Moonlight Head V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Walksnail Moonlight "head" for the SpeedyBee Master 3X. In also features mounting options for a GoPro Hero ND filter.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 171
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
Where to begin...
I needed a durable Caddx Moonlight head unit for my Master 3X. I also happen to use GoPro Hero ND filters because they're just better than the caddx ones so I made the filter adapter found here. The result is this head unit that started life as a monolithic PETG model and is now comprised of a hybrid of PETG and TPU components.
This is a design that has gone through dozens of iterations and finally feels good enough to put out. Due to the iterative design there are some design choices that may seem odd such as using inset TPU mounts to a TPU based head unit. I promise you they made sense at the time so please don't judge too harshly.
Note: The side walls of the main body are slightly visible at the edges of the camera but this was a tradeoff made to protect the camera and ND filter as much as possible. You can trim these back if you want.
TPU and PETG models are labeled below. All models should be printed with extra perimeters and top/bottom layers for durability. The main body should be printed with supports (and yes they are a pain to remove - sorry about that).
Other hardware required:
M2 rubber vibration dampeners: https://www.amazon.com/dp/B0BZNW6XT2
Assorted M2 sizes from 4mm-15mm
M2 nuts & washers