1 / 5
Tape dispencer - 50mm*20mm minimal - requires a bit of pin — zdjęcie 1
1 / 5

Tape dispencer - 50mm*20mm minimal - requires a bit of pin

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Problem: One looses tape end especially with these small and very durable rolls. I tried to make the cut edge only out…

Ocena
0 / 5
Polubienia
1
Pobrania
13
Wydruki
0
Wyświetlenia
266
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Problem: One looses tape end especially with these small and very durable rolls.

I tried to make the cut edge only out of plastic but it just kept stretching the tape. Maybe you have better luck.

I poked a piece of pin cut from the head of the pin. Warmed it up above a candle (thus the soot) and stuck it through the print. Might be good to not to make the needle dirty but this is just a concept... aand now it's permanent in my kitchen.

The pin will pierce the tape and it will break off very easily.

You can see how it works from attached link to youtube.

Print Settings

Printer Brand:

Prusa

Printer:

Mk2.5s

Rafts:

No

Supports:

No

Resolution:

200

Infill:

20

Filament: PolyMaker PLA

Notes:

12min print

Post-Printing =============

Add 5mm piece of pin to the 3d print to cut the tape.

Warm up the cut piece with pliers. Push the piece to 3d print and it will stick.

Category: Tablet

Tagi