Nissan LEAF AZE0 24kWh 30mm Fuse/Cutoff Bracket Spacer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
30mm spacer to lift the fuse+cutoff bracket inside the battery, if you're installing a large cell upgrade w/thicker seal
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 89
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
These models are to space your fuse/disconnect bracket up so it matches the lid on a Nissan LEAF battery cell upgrade. Some manufacturers provide a super thick seal to lift the lid up for more clearance.
Tested in a 2013 AZE0 24kWh battery, it SHOULD fit other 24kWh from the ZE0 or 30kWh batteries that use the same disconnect. 40kWh batteries may have a different bracket with different mounts, I've never seen one in person. I used it for my CVC 62kWh cell upgrade, since they just provided two oversized 30mm spacers for the four bolt bracket.
Print both the A and B parts and snap them into the dowels on the bracket before installing. It might be beneficial to hot glue them on so you don't have to deal with them falling out while connecting the cables and such. If your battery gets hot enough to melt PETG you might have other problems, so that should work if it's all you have. ASA/ABS would be ideal. Nylon/PC/etc is overkill since this is just under compression forces and common FDM 3D printed materials should be more than strong enough. DO NOT USE PLA for the love of god.