Nose pad for glasses (1mm screws)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement nose pad for glasses. Screw-on-style, oval pad. Quickly thrown together in Tinkercad. You can adapt the…
- Ocena
- 5 / 5
- Polubienia
- 24
- Pobrania
- 335
- Wydruki
- 3
- Wyświetlenia
- 1020
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
Replacement nose pad for glasses.
Screw-on-style, oval pad.
Quickly thrown together in Tinkercad. You can adapt the design to your needs here: https://www.tinkercad.com/things/fNcHToouGeY
Measurements:
Pad len = 13.4mm, pad width 7.4, pad thickness 2mm,
Centered square nub: 2x2mm (~2.5mm high at tip),
Screw hole at 1.5mm above pad surface, hole dia = 1mm.
Print Settings
Printer Brand:
Creality
Printer:
CR-10 Mini
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.12mm
Filament:
Innofil PETG
Natural
Notes:
Print standing on side for stability (extrusions will loop around hole, leading to much improved stability compared to printing laying flat). That's also why you need supports.
Print at 0.45mm extrusion width (0.4mm nozzle diameter) or smaller.Post-Printing
1. Drill out hole if too small
My printer tends extend print perimeters by around 0.15mm. That's why the hole, as printed, was too small (around 0.7mm), and I used a 1mm drill bit to carefully make it the correct size.
2. Sand the part that touches the skin
I used fine-grit sandpaper to smooth out any layer lines, particularly around the side edges. You should wash the part afterwards if you don't enjoy getting plastic particulates in your eyes (ask me how I know).
Category: Replacement Parts