Chair/Equipment Hanger - Lag Screw/Bolt with TPU Cushion (PLA Support)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple print to enable using a lag screw - with a TPU "cushion" to protect the chair finish - as a chair hanger.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 39
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Public Domain
This simple print was used to hang up some infrequently used chairs in a basement storage room (see photos). The same idea could be used to create wall hangers for equipment in the shop or garage. I used FLEX/TPU for this particular print, because I wanted a soft "cushion" for the chair finish, but other filaments could be used where that is not a issue. Note that in addition to acting as a cushion, the print also creates a rim which prevent the chair from from sliding off of the hanger.
For this print, I used a 1/4" X 2-1/2" hex head lag screw for the actual hanger part.
This print also incorporates another idea I have see elsewhere, that I wanted to try out - using PLA as support material for printing TPU. Also, I did not want to use slicer created supports with TPU as I found that this often created problems of stringing and blobbing. For the PLA support for this print, I created a small disk (see photos) that is printed in PLA prior to printing the TPU cushion. When the TPU cushion is printed, the print is paused at the appropriate level, the PLA disk is inserted, and the TPU print is resumed.
Important : Before inserting the PLA disk, I "painted" the top of the disk with a thin film of oil using a cotton swab, to help prevent the TPU from sticking to the disk, I used 3-In-1 oil, but any light oil should work.
Assembly and Use
Assembly is simple - after printing the TPU Cushion, pop out the support disk and insert the lag screw. The Cushion is designed so that there is room for a socket wrench to fit - simply screw the lag screw into the desired location (after drilling a pilot hole).
Print Instructions
Print the Cushion in FLEX (TPU) using the 3mf files provided, otherwise :
0.2mm layer height
3 perimeters
15% rectilinear infill
Print the Support in PLA - the print parameters are not critical.
CAD
The OnShape 3D CAD files for this are here :