Aprilia Tuareg 660 – Tower Reinforcement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tower reinforcement for the GiamaicaWorx “Front Rack” + “Device Holder”. Made for heavier tablets like the DMD T865
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 578
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
Compatible with: GiamaicaWorx Front Rack System (Front Rack + Device Holder) 🔗 https://www.giamaicaworx.com/front-rack-system/
If you're mounting a DMD T865, T880 using the road/adventure holder, there's also a adapter model for that: 🔗 https://www.printables.com/model/1500922-aprilia-tuareg-660-t865-gworx-device-holder-adapte
Overview
If you're using the GiamaicaWorx Front Rack + Device Holder with a heavier tablet (such as the DMD T865), you may notice the rack tends to flex, causing the tablet to wobble — especially off-road. This reinforcement eliminates that flex and makes the setup feel much more solid.
For complete rigidity, a fully custom tower would be the ultimate solution — however, these are quite expensive, and since this is a brand new bike I wasn't confident how Aprilia would handle potential warranty claims with a custom tower installed. This kit was, in my opinion, the good middle ground.
As demonstrated in this video, the difference is noticeable: 📹 https://www.youtube.com/shorts/J7xiosi4Yug
Note: Even with this reinforcement installed, there is still some visible flex in the upper part of the device holder — but it is substantially better than without it, and in practice it causes no issues while riding.
Design
Main piece — split design: The main structural piece is split into four parts to allow installation with no tower disassembly. If you prefer a single-piece version you can combine the parts.
Distance block: The distance block is not bolted to the main piece. Adding holes to connect them would weaken the main part, and since the block is captured in place and eliminates the room for flex, bolting them together is IMO not necessary. That said, I may revisit this decision ;-)
Materials
I printed mine in PC-CF from Prusa, but other materials like ASA or ABS should work well too.
Hardware
2× M4×20 screws + washers + lock nuts → required to mount the distance block to the Front Rack. Align the bottom of the piece with the rack cutout (see photos).
4× M5×30 screws + 4× enlarged washers + 4× lock nuts → required to install the side pieces into the tower and screw them together with the main peace. Insert the side pieces, lock in place with screws. Ensure the cutouts in the main piece and the distance block are aligned (see photos).
Testing
This setup has been tested on my 2025 Aprilia Tuareg Rally covering 500 km, roughly half of which was off-road. No signs of failure so far.
I'll update this as I put more kilometers on it.