1 / 1
Instax SQ1 cam gear with extended groove — zdjęcie 1

Instax SQ1 cam gear with extended groove

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

3D model for a cam gear from Instax SQ1

Ocena
0 / 5
Polubienia
2
Pobrania
10
Wydruki
0
Wyświetlenia
133
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Public Domain

This is a 3D model for a spur gear inside the Instax SQ1 that has a cam for a follower that lifts the card up and advances the frame counter during each development cycle.

On top of this gear there is a groove that the microswitch falls into, which triggers the cycle stop. If you mod this camera and remove the electronics to make the development manual, this mechanism can move a little by inertia after the motor is switched off and reset itself, starting another cycle. You may want to extend this groove to prevent this.

Default groove angular size is 30 degrees. In the files there are models with the groove that spans over different angles from 30 to 90 degrees with a 10 deg. step. 50 degree variant worked well for me, but your mileage may vary.

This part is made for an SLA print with a tough ABS-like resin!

The hole needs to be drilled with a 2.5mm drill.

There are also a couple more gears (24 and 25 teeth) that I accidentally broke and succesfully 3D printed. You can see them in the picture too. The 24 teeth one needs 2 mm hole, not 2.5 mm like other gears.

Tagi