Display Relocate for FlashForge Adventurer 5m
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This print will slightly raise and tilt back the screen on the AD5M. Helpful if the printer is lower than you.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 218
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
This print raises the display a few millimeters to allow clearance for a custom front door. It also tilts the display back for easier reading and operation if you are tall or the printer is on a low table.
Printing instructions
This part isn't subjected to a lot of heat or mechanical stress. Any plastic should work well. 0.20mm layer height works fine, and 10% infill is plenty.
Print orientation as shown in the 3D viewer above. (The side that interfaces with the back of the display should be touching the print bed.)
No supports required.
Installation
Preparation
To install, you will need:
2x 3mm screws that originally held the display on its shipping bracket
2.5mm hex driver for the 3mm screws
Double-sided tape, preferably VHB
Installation
If you're careful, you don't need to disconnect the display cable. The photos above show the orientation and position of this print (red) on the AD5M chassis.
Make sure you have all of the required hardware and tools within an arm's reach.
Cut two 25mm squares of VHB tape and affix to the bottom of the bracket
Gently slide the display to the right to disengage it from the printer body
Position this print on the back of the display and use the two 3mm plastic screws to attach the display to the print.
Set the display on the printer body and line up the 5mm hole in the print with the hole in the printer.
NB: There are provisions for a 5mm bolt and nut to affix the bracket to the printer body. However, unless you have a very low-profile bolt head, the print head will strike the bolt head when auto-leveling or printing near the front edge of the bed.