MDT SendIt Version 2 Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a case for MDT SendIt Version 2 to allow you to route fiber optic cable from the MDT SendIt unit to a ring on the ocular housing of your scope to see the lights while looking through the scope. Vertical case fits (2) M-lock holes/cutouts on a MDT ACC Chassis. Unit slides in the case and is attached with a screw from the MDT unit.
Case is printed using PETG, and Ocular Rings are printed using TPU.
Part Needed.
(1) 30 inches of .120 OD/.080 Core ID, fiber optic cable
(2) 10-24 x ¼" button head screws
(1) MDT SendIt Case (PETG)
(1) Ocular Housing Ring (TPU)
(1) ½ ID x 8" shrink wrap
Mount MDT unit/case and put ocular ring on the scope. Ocular ring should be as close as possible to the end of the eye piece.
Route the cables between the two and cut to length. Cut three cables to length. Add 3/8" to the length to account for cable that goes into the case and ring.
Cut shrink wrap about two inches shorter than cables. Put shrink wrap around cables and heat it to shrink it.
Press cables into case and ocular ring. The cables will press in hard. Press cables in until flush on the front of the ocular ring. Press cables into the case until they touch the unit and pull out slightly.