Whitehall Mystery component organizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A few simple prints to hold the cards, miniature, and tokens for Whitehall Mystery board game.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 28
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- GNU General Public License v3.0
Simple organizers for the components of Whitehall Mystery. I tried some other STLs and they didn't fit my pieces this game was just purchased in the US from a fresh run March 2026 and these were sized based on that run.
There are 2 parts, one for Jack and 3 for Investigators. I printed jack in black and the investigators in white. Jack is a little taller and only has 4 tokens the investigators are a little shorter and have 5 tokens. These sit in the factory box, as shown in the picture, with the screen, map, and rule book just sitting on top.
I like that you can just pull these out and hand them to people, not that this game had a lot of setup anyway but now you don't need bags and the components are a little more protected when not in use.
These were printed at .2 layer height, with 15% infill, and they're plenty sturdy. I doubt the infill matters much most walls are small enough to be solid anyway. Print flat on the print bed no supports necessary should be a very easy print.