1 / 7
Artika Sonolok Fastener-Free Valve Index Base Station Mount — zdjęcie 1
1 / 7

Artika Sonolok Fastener-Free Valve Index Base Station Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Cross mount sized for Artika Sonolok acoustic paneling. Held in place by friction (no fasteners through wall).

Ocena
0 / 5
Polubienia
0
Pobrania
2
Wydruki
0
Wyświetlenia
94
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Open Community License v1

This model is intended to mount base stations of the Valve Index on walls of a room with Artika Sonolok paneling, without holes or screws in the wall

The model is not perfectly symmetrical, to match the hole spacing and size of the Valve Index base station plate (one hole is closer to its edge than the other). The design sits at the junction of two rows of panels, relying on the upper row's slats to provide an opposing force to the weight of the base station hanging off the side.

To install, two M4x16 screws, two M4 washers, and two M4 nuts are required.

  1. Seat the nuts in the pockets on the backside of the print.

  2. Pop the base station plate's cosmetic hole covers out.

  3. Place an M4 washer in each newly exposed spotface, and pass an M4x16 screw through each washer.

  4. Pass the screw shafts through the clearance holes in the print opposite the nuts, and use a 3mm hex wrench to advance the screws until they catch the nuts, clamping the print and base station plate firmly together.

  5. Line the print up with the spacing in the paneling and test the fit without a base station attached first. If too loose, force some shims in any empty space to remove clearance and constrain the print more tightly.

I have not tested this print extensively yet, and urge caution to avoid tugging on the power cable that must be connected to the base station!

Prints in pictures are made using Micro Center's Sand PLA on a Core One L with 0.4mm HF nozzle, 0.28mm DRAFT preset at 10% grid infill.

Tagi